Page 2 of 4

Re: mystery tool

Posted: Sat Dec 04, 2010 1:30 am
by realityguy
I actually purchased this item for a future project after researching what was needed ;) :idea:



Must be an idiocy compensator then.. ..Did you get it to keep your whistle from blowing off? :roll:



:lol:

Re: mystery tool

Posted: Sat Dec 04, 2010 10:23 am
by Ridgerunner
Cuz, I hate to see you drain your brain :sci: trying to figure out the key usage of this tool but keep going :P :lol:

Re: mystery tool

Posted: Sat Dec 04, 2010 10:35 am
by sudden
A hole punch?

Re: mystery tool

Posted: Sat Dec 04, 2010 10:51 am
by Ridgerunner
sudden wrote:A hole punch?

Like to stamp out the 1 1/2" holw in the bottom of and aluminum can :D ....I wish, you are on the wrong track. Several guesses are in the neighborhood.

Re: mystery tool

Posted: Sat Dec 04, 2010 1:24 pm
by zelph
What are the dimensions of it?

Re: mystery tool

Posted: Sat Dec 04, 2010 1:54 pm
by realityguy
Okay..It's a swaging tool..Can I go home now? :roll:

Re: mystery tool

Posted: Sat Dec 04, 2010 2:00 pm
by zelph
It's the working end of an expansion plug.

Re: mystery tool

Posted: Sat Dec 04, 2010 3:39 pm
by Ridgerunner
Where is oops56 when you need him :lol: I will give you a hint: the answer lies in parts of this thread! :P :lol: :DP: :DB:

Re: mystery tool

Posted: Sat Dec 04, 2010 4:37 pm
by realityguy
I still don't think you are truthful... and it IS the idiocy compensator.. ;)
:lol:



It's your new(well..old) kelly kettle steam whistle...

Re: mystery tool

Posted: Sat Dec 04, 2010 5:47 pm
by Ridgerunner
Cuz, you crack me up! I had no idea how to do this project on the drawing board and after doing a google and youtube search, this is the tool that was recommended. Made sense to me and will to you too when I tell you what it is for! :P :lol: